Same-week bookings · tidy finish

Sockets, lighting & small worksacross Chepstow, Newport, Bristol & South Walesdone tidy, first time.

Extra sockets, lighting installs and rewires, kitchen and bathroom extractor fans, outdoor lights and small domestic electrical works. Straight call-out pricing, no over-selling.

Request a free quote Call 07491 966787

Free surveys · fixed-price written quotes · NAPIT registered

15+ yrs

Combined experience across Levi & Jay

NAPIT

NAPIT registered

Ohme

Accredited EV charger installer

5.0 ★

Google reviews from real customers

Insured

Public liability · employers' · indemnity

Overview

What this service is, and who it's for.

Straight explanation, no jargon padding, so you can decide whether it's the right call before you even ring us.

What it is: Small works covers everything short of a full rewire or fit-out: adding a socket, moving a socket, adding a spur, running a dedicated circuit for a new appliance, replacing light switches and fittings, installing recessed and pendant lighting, wiring in extractor fans in kitchens and bathrooms, installing outdoor lighting and outdoor sockets, and any other one-off domestic electrical job.
Who it's for: Homeowners tweaking a room or a whole floor after moving in, renovators finishing a kitchen or bathroom, landlords tidying up between tenancies, home workers who need proper power to a desk position, and anyone whose current setup involves a nest of extension leads.
When you need it: Book us before you need it, same-week appointments are usually available for straightforward small works. Emergency call-outs for immediate problems (a socket sparking, a light circuit dead) are available 24/7 at the out-of-hours rate.
Why professional matters: Small electrical work still has to comply with BS 7671. A DIY spur run from the wrong point on the ring final, or a light fitting installed with the wrong flex, is exactly the sort of thing an EICR picks up as a C2. Doing it right first time, properly cable-routed, properly protected, properly tested, is cheaper than doing it twice.

What happens if you leave it

The cost of putting it off is rarely just money.

Small electrical faults have a way of not staying small. The socket that gets a bit warm becomes the socket that arcs; the DIY extension lead becomes the melted plug. Small works done properly is the cheapest form of preventive electrical work there is.

What can go wrong

Overheated extension leads and multi-way adaptors that eventually fail unsafely.
Extractor fans wired to lighting circuits pulling them offline whenever the fan runs.
Outdoor lights on non-IP-rated fittings failing at the first winter storm.
DIY spurs picked up as C2 defects on the next EICR, costing more to remediate than to do right first time.
Bathroom lighting installed in the wrong zone, a genuine electrocution risk, not a technicality.

Common mistakes we see

Adding a spur from any socket without checking whether it's already on a spur.
Using flex where cable is required, or vice versa.
Installing a bathroom downlight or shaver point without checking IP rating and zone.
Running outdoor sockets from an unprotected internal circuit.
Ignoring the extractor fan run-on timer requirement in bathrooms without opening windows.

How we work

A five-step system, so nothing gets missed.

The same discipline we run on a single-socket call-out and a full commercial fit-out. Predictable, documented, tidy.

01
Inspection
Free on-site survey. We look at the existing installation, the space and the outcome you need, no pressure, no obligation.
02
Diagnosis & fixed quote
We scope the work, agree the spec in plain English and give you a fixed-price written quote with no hidden extras.
03
Booked-in works
We turn up when we say we will, protect the space with dust sheets and keep disruption to your day to a minimum.
04
Testing & verification
Every circuit is tested to BS 7671 (18th Edition). Nothing gets signed off until the readings are right.
05
Certification & handover
You get NAPIT-backed certification, a tidy handover and a clear explanation of what's been done and why.

Benefits

What you actually get from doing this properly.

Same-week appointments

Small works are usually in the diary within a few days, no ghosting, no missed appointments.

Straight call-out pricing

Clear call-out rates agreed before we come out, and surveys are always free.

Tidy finish

Dust sheets, minimal chase, proper making good, we leave the room looking like we were never there.

Certified on completion

Minor Works or Electrical Installation Certificate as appropriate, paperwork you keep for insurance and sale.

Honest advice

If a small job is really a symptom of a bigger issue, we'll tell you, not pad the invoice.

One contractor for future work

Same team you can call for the rewire, the EV charger or the EICR later, you don't have to explain your installation twice.

Detail

Materials, methods and the variations that matter.

The specifics, so you can compare us like-for-like against anyone else you're quoting against.

Working across:

Chepstow · Newport · Bristol · Cardiff · Bath · Gloucestershire · Caldicot · Magor · Undy · South Wales · South West

Extra sockets and spurs

Extra sockets are usually run as a spur from an existing ring final (one socket per spur, correctly cable-sized) or as a new circuit from the consumer unit if the load or count justifies it. We check the existing ring first, you can't spur from a socket that's already a spur, and we test the completed work before signing it off. Kitchen sockets go on dedicated cable behind units where possible so they're not disturbed by the next kitchen refit.

Lighting installations and rewires

Full room lighting rewires, replacement of pendants with recessed downlighting, installation of dimmable circuits with appropriate LED-compatible dimmers, two-way and intermediate switching for corridors and stairs, and outdoor lighting on separate switching or PIR control. All fittings selected for the zone and IP rating required, especially in bathrooms and outside.

Bathroom and kitchen extractor fans

Extractor fans in bathrooms and en-suites without opening windows are a Building Regulations Part F requirement. We install fans to the correct extraction rate, wired via a switched fused spur with a run-on timer where required, and vented externally through a wall or roof cowl. Kitchen extractors on separate switching so they're not permanently tied to the light.

Outdoor sockets and lighting

Outdoor sockets installed on a dedicated RCD-protected circuit (or via an RCBO), IP-rated to at least IP55, positioned to avoid direct rainfall where possible. Outdoor lights matched to the location's zone and finish, brass or stainless in coastal environments, powder-coated steel or aluminium inland. All fittings sealed to their gaskets and tested at commissioning.

Small works vs. a bigger job

Sometimes what starts as a small works enquiry, 'can you add a socket', turns out to be a symptom of a bigger issue like a full consumer unit at capacity, or an old circuit that's already carrying a hidden load. We'll be straight about it and quote the right work rather than paper over the problem. If it's genuinely a small works job, that's what we invoice.

Answers

Common questions on this service.

Still unsure? Ring us on 07491 966787 , surveys and quotes are free.

How much does adding a socket cost?+

Small works are charged as call-out plus materials at our agreed rate. Most single-socket additions are done inside the first-hour band; longer cable runs or dedicated circuits are quoted before we start.

How quickly can you come out?+

For small works we usually offer same-week appointments. For genuine emergencies (sparking sockets, dead circuits, loss of power) we're available 24/7 at the out-of-hours rate.

Can you install downlights in my bathroom?+

Yes, with the correct IP rating for the bathroom zone, fire-rated fittings if you're above another room, and appropriate LED drivers. We'll advise on layout at the visit.

Do you install outdoor sockets?+

Yes, on RCD-protected circuits, IP55 or higher, positioned to avoid direct rainfall. Certified on completion.

Will you replace my old light switches with dimmers?+

Absolutely, we use LED-compatible dimmers matched to the fittings you're keeping so you don't get flicker or buzzing. Bring us the lamp specifications and we'll choose the right dimmer.

Do I get a certificate for a small job?+

For any work that adds or alters a circuit you get a Minor Works Certificate or, for larger changes, an Electrical Installation Certificate. Keep it with your property paperwork.

Can you do work while I'm at the office?+

Yes, happy to hold keys for the day if we've done a survey and quoted first, or work while a family member is home. We're used to letting ourselves in and locking up cleanly.

Do you install extractor fans in bathrooms without windows?+

Yes, with run-on timers, sized to the correct extraction rate, vented externally. It's a Building Regulations Part F requirement in windowless wet rooms.

Are you qualified and insured?+

Yes. H&H Electrical is NAPIT registered, our EV work is NAPIT-accredited and Ohme approved, and we carry public liability, employers' liability and indemnity insurance in full.

Do you cover my area?+

We cover Chepstow, Newport, Bristol & across South Wales, the South West, Cardiff, Bath, Gloucestershire, Caldicot, Magor and Undy. Ring us if you're just outside, most of the time we can still help.

How do I pay?+

Bank transfer or cash. We don't take card. Small jobs are call-out plus materials; larger jobs are quoted at a fixed price up front so you know the total before we start.

Related services

Related work we do.

18th Edition

Back to homepage

5.0 on Google · NAPIT registered

Ready for a straight quoteon sockets, lighting & small works?

Free survey. Fixed-price written quote. Work booked in around you, usually the same week.